should i sleeve my cards Why ALL of cards, even the BASE! Do I Need to Sleeve

Stasis Snare can be a good inclusion in certain situations but may not always be the best choice for competitive play

even common cards can command impressive value

When printing the bins, I used the following settings: 10% Infill (adaptive cubic) PLA Add these if you have issues with Warping: Supports on Build Plate Only Smooth Sheet When printing mine, I have done the following: 15% infill (a little less would probably be fine) PLA No brim, although it would be safe to add a brim Textured/Smooth steel sheet depending on desired finish Upside-down inserts to maximize surface contact (and to add a finish to the top) Horizontal dividers for a textured finish Happy printing

Every week, but it's chaos